NAMCO SPIN THE SPIN Manual Del Operador página 48

7. Pull the snap pin off the
plunger's solenoid shaft,
remove the solenoid shaft,
and then remove the plunger.
8. Slacken the locking nut (M6)
and the pozi head screw
(M6x40) that hold the solenoid
bracket (A) and solenoid
bracket (B) in place.
9. Remove the 4 socket cap
screws (M5x12) that hold
solenoid bracket (A) in place
and remove the solenoid
bracket (A).
10. Remove the 4 socket cap
screws (M5x12) holding the AC
Solenoid in place and replace
the AC solenoid.
11. Reassemble in reverse order.
12. Adjust the AC solenoid. (see
section 7-2 "Adjusting the AC
Solenoid")
Page 48