NAMCO SPIN THE SPIN Manual Del Operador página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
NOTES ON INSTALLATION
NEVER turn the power to the machine ON until installation has
been completed.
In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
In order to avoid damage to the machine due to mis-operation, ensure
that the voltage of the mains supply is 230volts AC.
Note: If the location of this machine has a polished floor, it is recommended
that rubber pads are fitted under the level adjusters to prevent the
machine sliding on the floor.
Note: In order to gain access to the Power Supply and CPU assemblies, make
sure that the rear of the machine is separated from a wall or other
machine by at least 500mm.
This machine is fitted with castors to make it easier to move. Take care when moving the machine on an
inclined surface.
The overall height of the machine, with the Header Assembly fitted, is 1860mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
Adjustments or maintenance on this machine should be carried out by suitably qualified personnel only.
Do not make any alteration to this machine without prior approval. Doing so could cause unforeseeable
danger.
Only parts specified by Namco Europe Ltd should be used when replacing or repairing parts. (Including
screws).
Ensure that the power to the machine is turned OFF before commencing any maintenance work. (Trouble
shooting, repairs etc.)
If performing work not described in this manual, be sure to contact your distributor for instructions, as no
responsibility will be accepted for damage or injury.
Make sure that the machine is switched OFF before connecting or disconnecting any plugs or connectors.
When removing the mains connector from the machine, or the mains plug from the wall outlet, always
grasp the plug and not the cable.
MOVING THE MACHINE
REMOVING AND REPLACING PARTS

Publicidad

Tabla de contenido
loading

Tabla de contenido