Publicidad
Step 22
Step
Fasten the OUTER RIGHT END (A) to the TOP RIGHT
å
SIDE MOLDING (FFF) on the RIGHT TOP (G2). Tighten
two TWIST-LOCK® FASTENERS.
Fasten a SPACER (L4) to the OUTER RIGHT END (A).
å
Tighten two TWIST-LOCK® FASTENERS.
f a c
S u r
I S T
T W
S T
F A
Page 28
Surface with
TWIST-LOCK®
FASTENERS
L4
A
®
i t h
C K
e w
- L O
S
E R
E N
FFF
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of
the adjoining part.
NOTE: The dowel end of the FASTENER must remain
fully inserted in the hole of the adjoining part while
locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as
tight as possible.
Large hole should be located here.
G2
413670
®
FASTENER
Dowel end
www.sauder.com/services
Publicidad
