Publicidad
Step 32
Step
Fasten the NARROW EXTENSION RAILS (40NA) to the other surface
å
of the RIGHT UPRIGHT (E2) and KEYBOARD UPRIGHT (VV). Use four
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of
the EXTENSION RAIL in to fi nd the other hole that lines up with the
holes in the UPRIGHTS. Turn a SCREW into this hole.
Open end
1
Finished edge
Page 38
4
3
2
VV
2
3
4
Surface with
TWIST-LOCK®
FASTENERS
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
413670
KEYBOARD DRAWER
ON RIGHT
Open end
1
E2
3S
www.sauder.com/services
Publicidad
