Publicidad
Step
Step 55
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten the DOOR (P) to the INNER RIGHT END (B3). Use the
å
screws in the HINGES. See the next step for door adjustments.
Peel a FELT DISC from the FELT DISC CARD (1M) and stick it on the
å
DOOR where it comes in contact with the RIGHT UPRIGHT (E2).
Fasten a KNOB (33K) to the DOOR (P). Use a BLACK 1-1/8"
å
MACHINE SCREW (21S).
BLACK 1-1/8" MACHINE SCREW
(1 used for the KNOB)
www.sauder.com/services
21S
B3
E2
413670
KEYBOARD
DRAWER ON LEFT
Stop
Mounting
screw
Hinge
1M
33K
P
1M
Page 61
Publicidad
