How To Install The Optional Accessories - Hitachi SV 12SG Manual De Instrucciones

HOW TO INSTALL THE OPTIONAL ACCESSORIES

WARNING:
1. Installing the sponge pad (velcro type), the felt pad and the round rubber pad.
CAUTION: Replace only the pad and use the other parts just as they are. The sander
will vibrate greatly if parts other than the pad are removed or exchanged.
Be sure to switch power OFF and disconnect the plug to avoid
accidents.
4-3/8" × 4"
(110 × 100 mm)
Quick stick pad
4-3/8" × 4"
(110 × 100 mm)
Sponge pad
(Velcro type),
felt pad
Sponge pad or felt pad
Loosen the four M4 × 10
screws and remove the quick
stick pad.
5" (125 mm)
round rubber
pad
Tighten the four M4 × 10
screws and attach the
sponge pad, felt pad
or round rubber pad.
Fig. 7
English
Round
rubber pad
13