Bosch GTA3800 Instrucciones De Funcionamiento Y Seguridad página 11

BM 2610027815 03-13_BM 2610027815 03-13.qxp 4/2/13 8:47 AM Page 11
3. Place miter saw on top of the tool mounts,
Figure M. Align mounting holes by
adjusting rear sliding nuts and front swivel
nuts. Be sure the front of the saw is
aligned to the front of both tool mounts.
4. Place one (1) M6 flat washer onto one (1)
8 mm x 45 mm bolt, and insert through
RE R
SLIDING NUT
FRONT
SWIVEL NUT
REMo v E SAW FRo M STAND
(WITH To o L Mo UNTS ATTACHED)
1. Make sure the tool mount lock knobs on
each mount are in the open and unlocked
position (see fig. I, p10).
2. Locate the carry handles at the base of
the saw. Place one hand on the saw base
handle and the second on the saw's top
handle if available. Holding tightly, tilt the
saw (with the tool mounts still attached)
toward yourself and lift it from the stand.
ATTACH THE SAW To THE STAND
(WITH To o L Mo UNTS ATTACHED)
1. Make sure the tool mount lock knobs on
each mount are in the open and unlocked
position (see fig. I, p10).
2. Locate the carry handles at the base of
the saw. Place one hand on the saw base
miter saw base and loosely tighten into
tool mounts.
5. Repeat step 4 of this procedure for the
remaining three (3) hole locations.
6. Securely tighten all four (4) bolts. Do not
over tighten.
FIG. M
handle and the second on the saw's top
handle if available. Lift the saw to the rail
assembly.
3. Line up the left tool mount next to the red
secondary stop on the rail assembly as
close as possible.
4. Tilt the saw until the front jaws of both tool
mounts are engaged on the rail. With both
hands on the saw handles, guide the saw
back to its level position on the rail (See
Page 10).
5. Rotate lock knob on each tool mount to
the locked position (see fig. L, p10).
Be sure both tool mounts
!
W RNING
are in the locked position
before operating or transporting the saw.
-11-