Bosch GTA3800 Instrucciones De Funcionamiento Y Seguridad página 9

BM 2610027815 03-13_BM 2610027815 03-13.qxp 4/2/13 8:47 AM Page 9
TRANSpo RTING STAND WITH SAW
1. Make sure the tool mount lock knobs on
each mount are in the open and unlocked
position (see fig. I, p10).
2. Slide saw along table top surface until it is
against the Transport Stop (see page 8).
Note: For most comfortable transport, saw
should be positioned at the end of the stand
closest to the Transport Wheels. Adjust
Transport Stop, if necessary.
3. Close and lock the Extension Rails (see
page 12).
Note: Sticker designating lift handle location
affixed to stand end cap. These are your lift
handles and should be used when lifting the
stand for the following procedures.
FIG. G
4. Fold stand legs: Begin at end with installed
Transport Wheels. First, lift stand at
designated lift handle. Push in a leg locking
pin and rotate that leg up until the locking pin
clicks into place. (See page 6) Repeat for
second leg and lower stand down onto
wheels.
5. Repeat same step on opposite side, folding
legs into place.
6. To transport, grip the lift handle (Fig. G) and
roll to location on Transport Wheels (Fig. H).
7. To setup stand for use, follow same
instructions above, starting with either side of
stand desired.
FIG. H
-9-