Troubleshooting - Reliable Enviromate E3 Manual De Instrucciones

TROUBLESHOOTING

Do not operate the steam cleaner with a damaged cord, plug or if the steam
cleaner has been dropped or damaged. To avoid risk of electric shock, do not
disassemble or attempt to repair the unit on your own. Return the unit to Reliable
Corporation (see warranty) for examination, repair or replacement.
PROBLEM
No steam is released through
the steam fittings.
Drops of water leak from the
attachments.
Dirty water is coming out.
Not enough steam pressure.
POSSIBLE CAUSES
1. Steam unit is not turned on.
2. Water tank is empty.
3. Unit is not plugged in.
4. Generator is not fully
heated.
1. Unit is not fully heated.
2. Condensation was created
from non-use.
1. Scale may have built up.
1. The dial on the handle may
be set too low.
REMEDy
1. Turn steam unit onto the
2nd position.
2. Put required amount of
water into tank.
3. Plug unit into outlet.
4. Wait for light (3) to turn on.
1. Wait for light (3) to turn on.
2. Let water run through sys-
tem until steam comes out.
1. Follow cleaning instructions
in book.
1. Turn the dial until the de-
sired pressure is reached.
10