Using The Accessories - Reliable Enviromate E3 Manual De Instrucciones

USING THE ACCESSORIES

CONNECTING THE ACCESSORIES
Insert the plug at the opposite end of the steam gun/hose (11) to the connecting
outlet (10) all the way, making sure it cannot be pushed in further. Connect the
handle of the steam gun (11) to the extension tubes (12), pressing the locking but-
ton lightly until the button snaps in. All the accessories are connected
the same way.
The angle adapter (16) is used for the rectangular (13) and triangular (14) brush
in the following way: hold the brush in one hand with the bristles pointing down while
with the other hand inserts the angle adapter into the brush pointing it downward.
After this, turn the angle adapter 180º so that the line on the angle adapter and
the dot on the brush line up. When the line and the dot line up, you can adjust
the grey lever to the middle position (locked) to lock the brush so that it cannot
move, or to the position closest to you (rotate) to allow for the brush head to
rotate. To remove the brush, make sure the grey lever is in the position furthest
from you (assemble) and make sure the line on the adapter and the dot on the
brush line up. Rotate 180º to remove.
LARGE BRUSH
For cleaning hard floors, attach the extension tubes to the angle adapter to use
the large brush. Attach a dry cloth to the brush for the most effective cleaning.
CARPET SOLE
The carpet sole is used for "gliding" over carpets that otherwise would not be
possible without this attachment, however it is for spot cleaning only. To use this
accessory, snap it firmly (pushing down) into the large brush, making sure both
"pins" are firmly in place (you will hear two clicks). To remove it, push both "pins"
toward the outside of the brush, and lift out.
CLEANING CARPETS WITH BRUSH, CARPET SOLE AND CLOTH: (*THIS UNIT IS NOT
AN ExTRACTION CLEANER)
This steam cleaner cleans and disinfects all carpeting and rugs, even oriental
rugs, without the use of chemicals. The steam cleaner frees them from animal hair
and other unwanted items. It also renews the colours and raises the pile.
Start by vacuum cleaning the carpet to free it from dust and surface dirt. Wrap a
cloth around the brush. This way the brush will glide over the floors without any risk
of tearing the wool of the carpet. The turbulence produced by the steam and pres-
sure causes the dirt to be sucked up right onto the wiping cloth.
06