Accessories; Standard Accessories; Optional Accessories - Metabo HPT DH 38YE2 Manual De Instrucciones

English
Service and repairs
All quality power tools will eventually require
servicing or replacement of parts because of wear
from normal use. To assure that only authorized
replacement parts will be used, all service and
repairs must be performed by a
AUTHORIZED SERVICE CENTER, ONLY.
Service parts list
CAUTION:
Repair, modification and inspection of
G
Power Tools must be carried out by a
Authorized Service Center.
WARNING:
ALWAYS use Only authorized
accessories which are not intended for use with this tool. Contact
safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE:
Accessories are subject to change without any obligation on the part of the

STANDARD ACCESSORIES

(1) Case (Molded plastic) (Code No. 326489) ............ 1
(2) Side Handle (Code No. 313078) ............................ 1
(3) Dust Cover (Code No. 993245) ............................. 1
(4) Stopper (Code No. 971786) ................................... 1
OPTIONAL ACCESSORIES.....sold
separately
For accessories in detail please call
59-TOOLS
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (Spline shank)
External dia. Overall lenght
1"
(25 mm)
16"(400 mm)
1-1/2"
(38 mm)
12
01Eng_DH38YE2_US
This Parts List will be helpful if presented with
the tool to the
when requesting repair or other maintenance. In
the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
MODIFICATIONS:
and modified to incorporate the latest
technological advancements.
Accordingly, some parts may be changed without
prior notice.

ACCESSORIES

replacement parts and accessories. NEVER use replacement parts or
2. Anchor hole drilling (Rotation + Hammering)
(1) Drill bit
AT 1-800-
(2) Taper shank adaptor
A-taper
B-taper
Code No.
3. Large-dia. hole boring (Rotation + Hammering)
985375
985376
(Guide plate)
Code No.
985388
955169
12
Authorized Service Center
Power Tools are constantly being improved
if you are not sure whether it is
.
(3) Cotter
(Code No. 944477)
(2) Taper shank adaptor
(Taper shank) (Spline shank)
Taper shank adaptor formed
A-taper or B-taper is provided
as optional accessory, but drill
bit for it is not provided
(1) Center pin (2) Core bit
Code No. External dia.
955165 2" (50 mm)
4-1/8" (105 mm)
4/21/10, 4:26 PM
Code No. 985377
Code No. 985378
(3) Core bit
shank
(Spline
shank)