Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DS 56160/70/90 B IN
4 Study Figure A.
5 For wall installation drill three 8 mm holes every 100 mm in line with the hook of the hood.
6 Insert the rawlplugs.
7 Fix the hook to the wall and install the plate.
8 Fix the one-way valve with the screws supplied, add the reductor and the soot tube, and draw it outwards
(see Figure B).
9 Place on the wall (Figure C).
10 Calculate the final height of the U-shaped section and pull the inside of the U-shaped section up to the
correct height.
11 Secure the template in the lower tube using the screws supplied to mark out and drill two 8 mm holes in
the wall (Figure D).
12 Finally, drill two 8 mm holes in a suitable p lace in line with the second plate (Figure E) and tighten the
two screws.
THE CLASS 1 HOOD MUST BE EARTHED
The connection should be made as follows;
BROWN
BLUE
YELLOW/GREEN
THE CLASS 2 HOOD MUST NOT BE EARTHED
Second class hoods with the characteristics label containing the double square symbol.
The connection should be made as follows;
BROWN
BLUE
NOTICE OF INSTALLATION
1. Before installation, please ensure the area is clean to avoid suction of the remaining bits of broken wood
and dust.
2. It cannot share the same air ventilation tube with other appliance such as gas tube, warmer tube, and
hot wind tube.
3. The bending of ventilation tube should be≥120°, parallel or above the start point and should be
connected to the external wall.
4. After installation, make sure that the extractor is level to avoid grease collection at one end.
USE
Speed adjustment .See pictures Push button
1. Push stop button, and the motor will stop.
2. Push the Low button, the buzzer will buzz once, and the motor runs at low speed.
3. Push the high button, the buzzer will buzz once, and the motor runs at mid speed.
=
L (live)
=
N (neutral)
=
Earth
=
L (live)
=
N (neutral)
15
Publicidad
Tabla de contenido
