Orbegozo DS 56160 B IN Manual De Instrucciones página 17

DS 56160/70/90 B IN
BULB 2.5W max
SETTING UP AND CHANGING THE ACTIVE CARBON FILTER
This system is used in locations without ducting to the outside or when it is not possible to install such
ducting.
Disconnect the machine from the mains.
A. Remove metal filters.
B. The circular filters (Figure 2) are located at either end of the motor. Turn the
carbon filters anti-clockwise until they are unscrewed.
C. Apply reverse procedure to install the carbon filter.
Warning: the active carbon filter cannot be washed or recycled. It should be changed at least every
four months.
ABNORMITY AND SOLUTION
Fault Cause
Light on, but The leaf blocked
motor does The capacitor damaged
not work
The motor jammed bearing damaged
The internal with of motor off or a bad smell from the motor
Light does not Beside the above mentioned, check the following:
work, motor Light damaged
does not work
Power cord looses
Oil leakage One way valve and the air ventilation
entrance are not tightly sealed
Leakage from the connection of U-
shaped section and cover
Shake of the The leaf damaged and causes
body shaking
The motor is not tightly hanged
The body is not tightly hanged
Insufficient The distance between the body and
suction the gas top too long
Too much ventilation from open
doors or windows
The machine The fixing screw not tight enough
inclines
The hanging screw not tight enough
Replace lights
Connect the wires as per the electric diagram
Take down the one way valve and seal with glue
Take U-shaped section down and seal with soap
or paint
Replace the leaf
Lock the motor tightly
Fixed the body tightly
Readjust the distance
Choose a new place and resemble the machine
Tighten the hanging screw and make it horizontal
Tighten the hanging screw and make it horizontal
Solution
Get rid of the blocking
Replace capacitor
Replace motor
Replace motor
17