Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person is
recommended when assembling this
unit Take the unit out of its box and
make sure that all of the pieces are
there Fig.1:
(1) Monitor; (70) Main body; (73)
Handlebar; (72) Handlebar stem; (19)
Saddle post; (17) Saddle; (32) Rear
stabiliser bar with adjustable feet; (47)
Front stabiliser bar with wheels; (23L)
Left pedal; (23R) Right pedal; (81) Slot
head bolt M8x45; (45) Flat washer D8;
(4)
Hex
screw M8x15;(5)
washer D8;(75) Screw M4x35.
1. Position the machine's rear stand
on the rear stabilizer bar (32), as
shown in Fig.2, insert the bolts (81),
and then tighten securely.
2. Position the front stabiliser bar with
wheels (47) with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (81), and tighten securely.
3.- FITTING THE HANDLEBAR.-
Position the handlebar (73) on the
handlebar stem (72), Fig.4 and tighten
with
the
screws
washers (5), but make sure that the
handlebar is aligned correctly before
tightening the screws securely.
the handlebar cover (6)
Then insert the handlebar stem (72)
into the hole on the main body (70),
Fig.4. Position it correctly and then
tighten knob by turning it clockwise.
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Position the handlebar (73) at a
comfortable
distance
Spring
(4)
and
spring
Place
for
doing
exercise, now tighten knob securely,
Fig.4.
Stay within the references without
going beyond the "STOP" mark.
4.- ATTACHING THE SADDLE.-
Insert the horizontal saddle tube (19)
through the hole on the saddle post
(17), Fig.3, position it correctly and
tighten the knob, Fig.3.
Insert the saddle post into the boss on
the main body (70), position it correctly
and tighten the saddle post by using
the adjustment knob, Fig.3, turning it
clockwise.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob slightly by turning it anticlockwise,
move
the
comfortable for doing exercise and then
tighten the adjustment knob securely
by turning it clockwise.
Stay within the references without
going beyond the "STOP" mark.
HORIZONTAL
THE SADDLE.-
Loosen the knob slightly by turning it
anticlockwise, , move the saddle to a
position comfortable for doing exercise
and then tighten the knob securely by
turning it clockwise.
Stay within the references without
going beyond the "STOP" mark.
5.- ATTACHING THE MONITOR.-
Fit the monitor (1), Fig.4, into the
bracket (2) and insert the jack on the
middle cable into the back of the
monitor (See the instruction book for
the
monitor).
monitor with the screw (75).
9
saddle
to
a
ADJUSTMENT
Tighten
the
position
OF
cover
Publicidad
