Demolition Hammer Safety Warnings; Standard Accessories; Optional Accessories (Sold Separately) - Hitachi Koki H 45MR Instrucciones De Manejo

English

DEMOLITION HAMMER SAFETY WARNINGS

1. Wear ear protectors
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory
may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
SPECIFICATIONS
Voltage (by areas)*
Power Input
Full-load Impact Rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case ........................................................................... 1
(2) Bull Point (SDS-max shank) .................................. 1
(3) Side Handle .............................................................. 1
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES (sold separately)

Crushing
(1) Bull Point
Overall Length: 280, 400 mm
Asphalt Cutting
(1) Cutter
Surface Roughing
(1) Bushing Tool
5
(2) Shank
4. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
5. Even when the switch is on, the motor is running
and the tool head is pressed to the demolition
surface, the hammer sometimes does not start
operating. In these instances, turn the switch off,
press the tool head against the demolition surface
again, and turn the switch on and off. This should
start the demolition hammer operating. Repeat this
procedure for several minutes, and the demolition
hammer will heat, after which it will operate when
switched to ON-LOCK.
(110V, 120V, 127V, 220V, 230V, 240V)
950W*
3000min
5.9 kg
Tamping
(1) Rammer
Groove digging and edging
(1) Cold chisel
Overall length: 280, 400 mm
Scooping Work
(1) Scoop
Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
–1
(2) Shank