Preparing The Connection To The Flue; Connecting To The Flue Pipe - Dovre VIRTUS 50 GAO Instrucciones De Instalacion Y Uso

10
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the detachable parts from the appliance
before you begin its installation.
It is easier to move the appliance and to avoid
damage if the removable parts have been
removed.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
The appliance can be opened by first removing the top
plate (1) and then the cast-iron front (2) by lifting this
upwards in order to remove it from its projections.
1
2
The glass pane (4) can be removed by loosening the
screws of the bottom glazing bead (1) (these must not
be removed), and then loosening the screws (2) of the
top glass fixings (3).
Subject to change because of technical improvements
2
3
1
4
2
3
4
09-20022-042
1
Placing the stove
Preferably place the stove on a flat floor. The appli-
ance is fitted with adjustable feet in the floor plate
so that the appliance can be adjusted and made per-
fectly level.
Take the distance from combustible material into
account. See the appendix "Distance from com-
bustible material".
Preparing the connection to
the flue
When connecting the stove to the flue, you can
choose to connect to the top or to the back of the
stove.
Connecting to the back
The stove is ready to be connected to the back upon
delivery.

Connecting to the flue pipe

The connection collar must be hermetically
attached to the chimney.
09-20022-043
The connection pipe, diameter 150 mm, must be
connected to the cast-iron collar.
PH2
09-20022-044
D OVRE
7