Installing The Remote Control Set - Dovre VIRTUS 50 GAO Instrucciones De Instalacion Y Uso

Installing the remote control
set
The Mertik Maxitrol GV60 remote control set consists
of a handset (transmitter) and a receiver. The system
works on batteries; connecting an AC adaptor is
optional.
The batteries (2 x 1.5 Volt AAA for the handset
(transmitter), 4 x 1.5 Volt AA for the receiver)
are included.
Use only the Mertik Maxitrol AC adaptor or an
adaptor preapproved by Mertik Maxitrol. Other
adapters probably do not suit your system
and/or can damage it.
Batteries – handset (transmitter)
▪ 2x 1.5 Volt AAA (LR 03) (recommended quality:
alkaline).
▪ Handsets with display: Battery indicator on the dis-
play.
▪ We recommend that you replace the battery after 2
years.
Batteries – receiver
▪ 4x1.5 V AA (recommended quality: alkaline)
▪ indicator light Battery nearly empty: beeps regularly
for 3 seconds if the motor is running.
▪ An AC adaptor may have to be used instead of bat-
teries.
Insert the batteries in the transmitter (handset) and
in the receiver (black box, lid can be opened eas-
ily).
The receiver is situated in the base of the appli-
ance: this is easy to reach by removing the two
knurled screws (1) and letting the cover (2) drop
down; see the following figure.
Subject to change because of technical improvements
2 1 3 5 4
6 7 5
Programming the electronics code
Codes selected from approximately 65,000 randomly
available codes are automatically assigned to all Mer-
tik Maxitrol electronics. This code is assigned to the
handset for the remote control set. The receiver must
read this code from the handset.
The code only has to be set once, thus not
when you replace the batteries in the handset
or receiver.
1. Press the receiver's reset button and continue
pressing until you hear two beeps; see next figure.
Release the reset button after the second beep.
The first beep is short and the second is long.
2. Within 20 seconds press the button
flame) on the handset until you hear two additional
short beeps. The code is now set. If you hear a
long beep, this means that programming the code
was not successful, for example because the wir-
ing is incorrect. Check the wiring and try again.
09-20022-041
09-20020-216
(small
D OVRE
9