Publicidad
Idiomas disponibles
Idiomas disponibles
English
► Hold upper handlebar (2) against lower han‐
dlebar (3) so the bores align.
► Push bolts (4) through bores (5) from the out‐
side to the inside.
► Fit washers (6) and screw on nuts (7).
► Press cable clips (8) onto the upper handle‐
bar.
► Insert cables (9 + 10) in cable clips (8).
► Close cable clips (8) and allow the tab to
engage.
► Fasten motorstop cable (9) and self-propulsion
cable (10) on the right on the upper handlebar
using cable clip (8), maintaining the distance a
= 37 - 39 cm.
► Fasten motorstop cable (9) to the centre of the
rear transport handle using cable clip (8).
► Press self-propulsion cable (10) into
guide (11) on the detent segment.
6.2
Adding Engine Oil
The engine oil lubricates and cools the engine.
The engine oil specification and capacity can be
found in the engine instruction manual.
26
7 Refuelling the Lawn Mower
NOTICE
■ The lawn mower does not contain any engine
oil on delivery. Starting the engine with no or
too little engine oil may damage the lawn
mower.
► Always check the engine oil level before
starting and if necessary top up.
► Add the engine oil as described in the engine
instruction manual.
7
Refuelling the Lawn Mower
7.1
Refuelling the Lawn Mower
NOTICE
■ The lawn mower may be damaged if the cor‐
rect fuel is not used.
► See the engine instruction manual.
► Stop the engine.
► Place the lawn mower on a level surface.
► Clean the area around the fuel tank cap with a
damp cloth.
► Turn fuel tank cap (1) anti-clockwise until it
can be removed.
► Remove the fuel tank cap.
► Add fuel using a suitable funnel, stopping at
least 15 mm short of the fuel tank brim.
► Place the fuel tank cap on the fuel tank.
► Turn the fuel tank cap clockwise and tighten
firmly by hand.
The fuel tank is sealed.
8
Adjusting the Lawn Mower
for the User
8.1
Folding Up and Adjusting the
Handlebar
► Stop the engine.
► Detach the spark plug socket.
► Place the lawn mower on a level surface.
0478-111-9657-A
Publicidad
Capítulos
