Final Assembly; Programming; Extra Features (Sync) - Metra 99-5841B Instrucciones De Instalación

PROGRAMMING

1. Refer to step 2 from the Installation section.
2. Press the push-to-start button to start the vehicle.
3. Program the kit:
a. Once the touchscreen display loads up, select the vehicle type.
b. Wait until the radio comes on, and the touchscreen display shows SWC Configured.
This process may take up to 3 minutes.
Note: If the touchscreen display does not load up, or the radio doesn't come on within
3 minutes, and/or the touchscreen display does not show SWC Configured, check all
connections, then reset the interface and try again. Refer to the Troubleshooting section.
4. Cycle the key off. If the driver's door is closed, open and close the door. Cycle the key back on.
5. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The compass in the driver's information center will no longer be functional.

FINAL ASSEMBLY

1. Secure the completed assembly into the dash using the factory hardware removed in step 7
of dash disassembly. Only use the upper mounting tabs.
2. Snap the radio trim panel with touchscreen display over the completed assembly, and then
reassemble the dash in reverse order of disassembly.
EXTRA FEATURES
SYNC (4.2-inch display screen models only):
If the vehicle is equipped with SYNC, the 99-5841CH can retain this feature.
1. Change the source of the radio to AUX-IN.
2. Press the Info button on the touchscreen display to enter the SYNC menu.
3. Press the climate control icon button to get back to the main menu.
11
REV. 8/31/2020 INST99-5841B