Final Assembly - Metra 99-5835G Instrucciones De Instalación

1. Cut the shaded portion from the sub-dash of the vehicle to allow the radio to fit.
(Figure A)
2. Locate the factory wiring harness and antenna connector in the dash and
complete all necessary connections to the radio. Metra recommends using the
proper mating adapter from Metra and/or AXXESS. Test the radio for proper
operation.
3. Secure the radio into the dash.
4. Snap the radio trim panel over the radio, and then reassemble the dash in
reverse order of disassembly.
99-5835G

Final Assembly

(Figure A)
5
Remove shaded area