Jonsered GC2128C Manual De Instrucciones página 16

Ocultar thumbs Ver también para GC2128C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STARTING AND STOPPING
Repeat pulling the cord until the engine
attempts to start. Move the blue engine
choke lever to the ½ position. Pull starter
rope until engine runs. Move the blue en-
gine choke lever to the opened position.
NOTE:
If engine dies, return blue engine
choke lever to the closed position and
repeat starting steps.
CAUTION! Do not pull the starter cord all
the way out and do not let go of the starter
handle when the cord is fully extended.
This can damage the machine.
Warm engine
With a warm engine, move the blue engine
choke lever to the ½ position. Pull starter
rope until engine runs. Move the blue
engine choke lever to the opened position.
CAUTION!
Do not put any part of your body in marked
area. Contact can result in burns to the
skin, or electrical shock if the spark plug
cap has been damaged. Always use
gloves. Do not use a machine with dam-
aged spark plug cap.
545186857 Rev. 9
5/15/12
Stopping
Stop the engine by pushing and holding
the stop switch in the STOP position until
the engine stops.
CAUTION! The stop switch automatically
returns to the start position. In order to pre-
vent unintentional starting, the spark plug
cap must be removed from the spark plug
when assembling, checking and/or per-
forming maintenance.
WARNING:
When the engine is
started with the choke in the closed
position the cutting attachment will
start to rotate immediately.
English--- 16

Publicidad

Tabla de contenido
loading

Tabla de contenido