Maintenance; Seat Cover - Britax EMBLEM Guia Del Usuario

BRITAX Child Safety, Inc.

Maintenance

IMPORTANT: Before each use, check this child seat and
its components to make sure they are in good condition
and good working order.

Seat Cover

Removing the Cover
Never remove the buckle tongues from the harness.
They cannot be reattached after removal. If reassembled
incorrectly, the child seat may not perform as intended.
1. Loosen and unbuckle the
harness.
a. Lift harness adjuster
lever.
b. Pull both harness
straps forward.
c. Unbuckle the
harness.
2. Open the chest clip.
a. Press tabs
b. Pull apart
3. Remove the infant
positioning pillow if
necessary.
4. Remove the belly pad and
buckle.
a. Lift the cover from
the seat to find
the buckle strap
connection.
b. Remove the buckle
strap by turning
the buckle retainer
sideways and
routing it out of the
front buckle slot in
the child seat (see
page 35).
32
1b
1a
b
a
4a
4b
EMBLEM/ALLEGIANCE User Guide
c. Slide the end of the
belly pad over the
comfort foam on the
seat.
d. Pull the end of the
belly pad and buckle
retainer out of the
buckle slot in the
cover to remove.
e. Turn the buckle
retainer sideways
and slide the buckle
out of the belly pad.
5. Detach the hook and loop
fasteners on the head
restraint/head pad cover
from around the harness.
6. Remove the head
restraint/head pad cover.
a. Raise the harness to
the highest position.
b. Detach the elastic
straps from the tabs
behind harness
height adjuster.
c. EMBLEM: Detach
the hook and loop
fastener from behind
the harness height
adjuster and lift
cover off.
ALLEGIANCE: Lift
cover over harness
height adjuster.
7. Adjust the harness to
the lowest position and
detach the plastic hooks
from the bottom edge of
the child seat.
4c
4d
4e
33