Lap-Shoulder Belt Installation - Britax Essentials EMBLEM Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BRITAX Child Safety, Inc.

Lap-Shoulder Belt Installation

1. Loosen the harness.
a. Lift harness adjuster
lever and pull both
harness straps
forward.
b. Remove the infant
positioning pillow
and unbuckle the
harness.
2. Recline the unoccupied
child seat to position 3
and place rear-facing on
the vehicle seat (see page
24). Ensure that no more
than 3 in. (7.6 cm) of the
base hangs over the edge
of the vehicle seat.
3. Pull the head restraint/
head pad cover up,
then pull the seat cover
forward to access the
rear-facing belt path.
4. Open the blue lock-
off closest to where
the vehicle belt will be
buckled.
a. Open the locking tab.
b. Open the clamp.
5. Route the vehicle belt
through the rear-facing
belt slots, ensuring that
the vehicle belt is routed
under the harness buckle
strap.
NOTE: The buckle should
be in the inner slot.
6. Ensure the vehicle belt is
not twisted and buckle
the seat belt.
7. Push down into the
middle of the child
seating area with
moderate force while
removing all slack from
the bottom (lap) part of
the vehicle belt and close
the lock-off (see page 24).
IMPORTANT:
Both the
vehicle lap and shoulder
belts must be routed
through the lock-off.
10
3"
4b
4a
Clamp
Locking
Tab
EMBLEM/ALLEGIANCE User Guide
8. Push down into the middle
of the child seating area
with moderate force while
pulling the top (shoulder)
part of the belt between
the belt slots to remove
any remaining slack
through the lock-off.
9. Replace the seat cover.
Rear-Facing Installation with Lap-Shoulder Belt
9 Check that all connections are secure and straps are not
twisted.
9 Check that no more than 3 in. (7.6 cm) of the base hangs
over the edge of the vehicle seat.
9 Check that the child seat cannot be moved front to back
or side to side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 Check that the back angle of the child seat is 30° – 45°
from vertical (not to exceed 45°) when the car is parked
on a level surface. See "Seat Positions" on page 24.
11

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Essentials allegiance

Tabla de contenido