EGO ST1500F Manual Del Operador página 22

ADJUSTING CUTTING
LINE LENGTH
The trimmer head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or worn,
additional line can be released by lightly
tapping the trimmer head on the ground
while operating the trimmer (Fig. 13).
WARNING:
the line cutting blade assembly. Excessive line length will cause the motor to overheat
and may result in serious personal injury.
For best results, tap the trimmer head on bare ground or hard soil. If line release is
attempted in tall grass, the motor may overheat. Always keep the trimming line fully
extended. Line release becomes more difficult as the cutting line becomes shorter.
LINE REPLACEMENT
NOTICE: Always use the recommended nylon cutting line with a diameter that does not
exceed 0.095 in. (2.4 mm). Using line other than that specified may cause the string
trimmer to overheat or become damaged.
WARNING:
off and become dangerous projectiles.
WARNING:
tool before servicing, cleaning, changing attachments or removing material from the
unit.
1. Remove the battery pack.
2. Rotate the spool retainer in the
arrow direction as necessary to
align the LOAD line on the spool
retainer with the eyelets in the spool
base (Fig. 14).
22
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER
Do not remove or alter
Never use metal-reinforced line, wire, or rope, etc. These can break
To prevent serious personal injury, remove the battery pack from the
13
14
Eyelet Arrow Direction
LOAD Line