EGO ST1500F Manual Del Operador página 29

4. Mount the nut onto the shaft
and turn it clockwise by hand to
pre-tighten it (Fig. 29).
5. Wear gloves to hold the spool base
with one hand, and, with the other
hand, use a socket wrench (9/16",
14mm) to tighten the nut onto the
shaft.
6. Fit the spring into the spool base
and make sure it is pressed into
position (Fig. 22).
7. With one hand holding the spool
base, use the other hand to grasp
the spool retainer and align the tabs
on the spool retainer with the holes
in the spool base. Use your palm to
press and rotate the spool retainer
left and right until the tabs lock with
the spool base (Fig. 19 & 20).
8. If any parts of the spool retainer assembly are damaged or worn, replace the
damaged part and reassemble them as following showing (Fig. 30).
NOTICE: If the spool retainer assembly is disassembled, during reassembly, ensure that
the notch in the wire holder is correctly aligned with the corresponding tab in the head
housing (Fig. 30).
CLEAN THE UNIT
◾
Clear any grass that may have wrapped itself around the motor shaft or trimmer head.
◾
Use a small brush or a small brush and a small vacuum cleaner to clean the air
vents on the rear housing.
◾
Keep the air vents free of obstructions.
◾
Clean the unit using a damp cloth with a mild detergent.
◾
Do not use any strong detergents on the plastic housing or the handle. They
can be damaged by certain aromatic oils, such as pine and lemon. Do not use
solvents such as kerosene. Moisture can also cause a shock hazard. Wipe off any
moisture with a soft dry cloth.
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER
29
30
Location
Housing
Nut
Spool Retainer Assembly
Screws
Wire Holder
Slot Cover
Head Housing
29