Bosch JS572E Instrucciones De Funcionamiento Y Seguridad página 10

BM 2609932805 12-11:BM 2609932805 12-11.qxp 12/6/11 8:43 AM Page 10
If the "Lock-ON" button is
WARNING
continuously being depressed,
the trigger can not be released.
WORK LIGHT
Your tool is equipped with a work light for better
visibility during operation. The tool power cord
must be plugged into a power source before
you activate the light. To turn light ON depress
the work light ON/OFF switch. To turn light off
depress the ON/OFF switch again (Fig. 1).
CONSTANT RESPONSE CIRCUITRy
The internal electronic feedback system
provides a "soft start", which will reduce the
stresses that occur from a high torque start.
The system also maintains the selected
speed under load for maximum efficiency.
BLADE ORBIT SELECTOR LEVER
Maximum cutting efficiency can be obtained
by adjusting the blade orbit selector lever to
suit the material being cut.
The following chart will help you determine
which setting to use for your application. This
chart is intended as a guideline only, and test
cuts in scrap material should be performed
first to determine the best setting.
blades, grit edge blades, rasp work and
down cutting blades.
more important than a clean cut.
CHIP BLOWER
Your jigsaw is equipped with a two position
chip blower to help keep the cutting line clear
of chips.
Setting O
Hard materials such as
metals or thin sheet
metals. This setting can
be used with knife
Setting I
Soft materials where
cleaner cutting or
delicate scrolling work is
performed.
Setting II
Medium density
materials such as
harder woods or particle
board.
Setting III
Soft materials such as
wood, plastics, etc. and
when fast cutting is
By adjusting the chip blower lever the force
of the discharge air may be altered as
follows;
BLOWER SWITCHED ON
For working with wood,
plastic and similar materials
that produce large amounts
of sawdust.
BLOWER SWITCHED OFF
For working with metals
and when cooling agents
are used, or with dust
collection accessory.
FOOTPLATE ANGLE ADJUSTMENT
The footplate may be tilted to allow angle cuts
up to 45° in either direction (Fig. 6).
Note: before adjusting the footplate, remove
dust shroud and anti-splinter if used.
Open the lock lever to unlock footplate. Push
and hold the footplate firmly towards the back
of tool as shown. While holding the footplate
backwards tilt footplate to desired angle on
bevel scale, then release pressure on footplate
so it engages into detent at desired angle (Fig. 6).
Your tool has detent slots the footplate will
engage at 0° & 45°, and there are additional
position marks for 15°, 22.5° and 30° angles.
Close the lock lever slowly to assure that
footplate is locked at the desired angle.
FIG. 6
FOOTPLATE
1
± 45°
1
-10-
2
LOCK
LEVER
BEVEL
SCALE
2
3