Bosch JS572E Instrucciones De Funcionamiento Y Seguridad página 9

BM 2609932805 12-11:BM 2609932805 12-11.qxp 12/6/11 8:43 AM Page 9
ATTACHING STEEL OVERSHOE
Your tool is equipped with a protective plastic
overshoe that protects finer surfaces. An
optional heavy-duty steel overshoe for work in
rough conditions is sold separately.
To attach, slide overshoe in direction of arrow
completely onto metal footplate (Fig. 4).
ANTI-SPLINTER INSERT
To minimize splintering of the top surface of
FIG. 4
PLUNGER SPEED
The jigsaw cutting speed or stroke rate
required depends on the material being cut,
the type of blade being used, and the feed rate
preferred by the operator.
The best speed for a particular application is
largely determined by experience though as a
general rule, slower speeds are for denser
materials and faster speeds for softer materials.
Note: that when the jigsaw is used at low
speed settings for an extended length of time,
the motor temperature will rise due to slower
speeds of the internal cooling fan. In such
cases, it is necessary to occasionally run the
tool at full speed for a few minutes to keep the
motor running at high efficiency.
VARIABLE SPEED DIAL
Your Jigsaw is equipped with a variable speed
dial. The blade stroke rate may be adjusted
during cutting operation by presetting the dial
on or between any one of the six numbers (Fig. 5).
Setting SPM rating (strokes per minute)
JS572E
1 800 Max.
2 1200 Max.
3 1600 Max.
4 2000 Max.
5 2400 Max.
6 2800 Max.
SLIDE ON-OFF SWITCH
(Model JS572EB only)
The tool is switched "ON" by the switch button
located at the side of the motor housing. The
the material being cut, place the JA1008 anti-
splinter insert in the blade opening of the
footplate's plastic overshoe (Fig. 5).
Note: The anti-splinter insert cannot be used
when the footplate is tilted for angle cutting.
Note: This insert will only work with blades that
have ground sides such as T301CD, T101B,
T101D, and T101DP.
FIG. 5
ANTI-SPLINTER
STEEL
OVERSHOE
Operating Instructions
switch locks in the "ON" position, a
convenience for continuous operation (Fig. 1).
TO TURN THE TOOL "ON" slide the switch
button forward.
TO UNLOCK THE SWITCH, slide the switch
button backward.
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The speed can
be adjusted from the minimum to maximum SPM
as set on the variable speed dial by the pressure
you apply to the trigger. Apply more pressure to
increase the speed and release pressure to
decrease speed.
Regardless of the pressure applied on the
trigger, the tool will not operate any faster than
maximum speed setting selected on the
variable speed dial.
"LOCK-ON" BUTTON (Model JS572E only)
JS572EB
The "Lock-ON" button, located in the handle of
800
your tool allows for continuous operation at
1200
maximum preset SPM without holding the
1600
trigger (Fig. 1).
2000
TO LOCK TRIGGER "ON": squeeze trigger,
2400
depress button and release trigger.
2800
TO UNLOCK THE TRIGGER: squeeze trigger
and release it without depressing the "Lock-
ON" button.
-9-
INSERT
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
(Model JS572E only)
FOOTPLATE'S
PLASTIC OVERSHOE