Install Appliance; Mount To Cabinet - Gaggenau BS 474/475 6 Serie Instrucciones De Instalación

Install Appliance

Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical
connections.

Mount to Cabinet

Use the included retaining plate and two screws to
fasten on the side bottom of the hinge side in the
installation cabinet. Mark the screw midpoint, the
retaining plate must be positioned precisely. Depending
on the installation situation, on partition floor or heating
drawer WS4.., turn the retaining plate by 180°. When
pushed into the cupboard, the appliance snaps into the
retaining plate.
Secure the appliance against tilting in the cupboard if
there is not intermediate shelf above the appliance:
fasten two commercially available brackets on both
sides inside the cupboard (at 17
" (5 mm) above appliance height).
16
3 / " (450 mm) deep, 3 /
4
1 Push the appliance fully into the kitchen unit. Route
the Combi-steam oven's connecting cable and
supply and drain water hoses to the connection
points on the rear left in the kitchen unit.
Do not kink or jam connecting cables and hoses or
route them over sharp edges.
2 Align the appliance in the center.
An air gap of / " (5 mm) is required between the
3
16
appliance and adjoining furniture frontages.
9