Features; Starting The Ice Machine; Initial Start-Up - GE UCC15NP Manual Del Propietario E Instrucciones De Instalación

Features

Control panel
Water filter
access door

Starting the ice machine

This machine takes in room temperature air at the lower
right front and forces warm air out the lower left front.
Restricting the airflow or operating the machine in a hot
or cold environment will adversely affect the ability of the
ice machine to make ice.
When the door is opened, the control panel, ice making
area and ice storage bin are visible. The scoop is located
in a holder on the inside of the door.
This is a gravity drain model that must have a building
drain connection below the level of the drain tube at the
back of the cabinet. A pump can be installed, which can
force drain water up a maximum of 8 feet, allowing it
to be located where a gravity drain isn't available.
Accessories on page 27 for more information on the
drain pump.
Initial Start Up
1. Turn on the water supply.
2. Switch on the electrical power.
4. Water will begin to flow into the unit. When the
reservoir is full, water will start to drain from the
machine. After a few minutes the compressor, water
pump and fan motor will begin to operate as the first
ice making cycle begins.
8
Light
Water filter
Kick Plate
See
storage bin. The machine makes 24 cubes at a time.
time to fill the ice bin. When the ice bin is full, the ice
the ice level falls, either from use or normal meltage.
Warm Air Out
49-1000640 Rev. 0