Lubricate O-Rings; Connect Hoses And Water Supply - Briggs & Stratton PW101-2010 Manual Del Operador

Lubricate O-Rings

Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or
synthetic grease) during assembly helps seat o-rings
properly and provides an improved seal. It also helps
protect the o-ring from damage by abrasion, pinching or
cutting and extends the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the high pressure hose (pump
end) (A), high pressure hose (gun end) (B), garden hose
to the pump (C), and plastic wand (gun end) (D).
Lubricate all connections shown below, following
these instructions:
1. Inspect and clean connecting surfaces prior to
lubrication and assembly.
2. Use lubricants sparingly during assembly; a light film
is all that is required.
3. Use a small brush or cotton swab to apply grease
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).

Connect Hoses and Water Supply

NOTICE Use ONLY cold water (less than 100°F).
1. Attach garden hose (50 ft. / 15.24 m maximum) to
water supply and run water through garden hose for
30 seconds to flush the hose of debris. Turn off water.
2. Confirm that water inlet screen (E) and black rubber
washer (F) is installed in water inlet coupling (G).
3. Attach water inlet coupling (G) to right side (viewing
from rear) of main unit as shown. Tighten by hand.
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
4. Attach garden hose (H) to the water inlet coupling (G).
Tighten by hand.
A
C
D
B
F
G
5. Attach high pressure hose (J) to the unit's water outlet
(K) located on left side (viewing from rear) of main
unit. Tighten by hand.
K
J
6. Attach other end of high pressure hose to the spray
gun. Press red button (L) on spray gun, then insert
end of high pressure hose (J) into gun until it SNAPS
into place. Release the red button and make sure
connection is secure.
Connect Wand and Spray Tip
1. Turn ON water, point gun in a safe direction, press
trigger lock button (M), then squeeze trigger to purge
pump system and spray gun of air and impurities.
2. Insert and twist plastic wand (N) into spray gun (P).
Once wand slides into gun, apply further inward
pressure to wand and twist 1/4 turn clockwise until
securely in place.
E
3. Turn OFF water and release trigger. Point gun in
a safe direction and make sure trigger cannot be
squeezed.
4. Insert the spray tip (R) into plastic wand (N). Once
spray tip slides into gun, apply further inward pressure
H
until it SNAPS into place.
5. To remove spray tip, press release button (S) on wand
and pull it away from the wand.
L
J
N P
R
M
N
S
7