General Inspection - Silverline Silver Storm 243009 Manual Del Usuario

243009
Maintenance

General inspection

• Regularly check that all the fixing screws are tight. They may vibrate
loose over time
• Inspect the supply cord of the tool, prior to each use, for damage or
wear. Repairs should be carried out by an authorised Silverline/Triton/
GMC service centre. This advice also applies to extension cords used
with this tool
Cleaning
WARNING: ALWAYS wear protective equipment including eye protection and
gloves when cleaning this tool.
• Keep your tool clean at all times. Dirt and dust will cause internal parts to
wear quickly, and shorten the device's service life
• Clean the body of your machine with a soft brush, or dry cloth
• Never use caustic agents to clean plastic parts. If dry cleaning is not
sufficient, a mild detergent on a damp cloth is recommended
• Water must never come into contact with the tool
• Ensure the tool is thoroughly dry before using it
• If available, use clean, dry, compressed air to blow through the ventilation
holes (where applicable)
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Hook and loop surfaces
• Hook and loop surfaces need to be clean, free of dirt and foreign matter,
such as hair, fibres, sand etc.
• In order to provide adequate adhesion for securing accessories, hook and
loop surfaces must be in good condition
• When used extensively, hooks and loops will become elongated or
broken, and the mechanism cannot provide the required strength of
adhesion anymore
Note: This sander's hook and loop sanding base is NOT a warranty item.
Replacement plates can be fitted at an authorised Silverline service centre.
Detail Palm Sander 140mm
www.silverlinetools.com
7