Troubleshooting - Silverline Silver Storm 243009 Manual Del Usuario

GB

Troubleshooting

Symptom
No function when On/Off
Switch (5) is operated
Slow material removal
Scratches on workpiece
after sanding
Burn marks on workpiece
Excessive dust emission
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
8
Possible cause
No power
Defective On/Off Switch
Sanding sheet too fine or worn
Sanding sheet too coarse
Not enough material removed
Sanding sheet incompatible with material
Too much pressure exerted on to the sander
Vacuum dust extraction system not connected, or
extraction system not switched on
Dust extraction not working; sanding sheet not aligned
with dust extraction holes in the Sanding Base; extraction
holes blocked
Solution
Check power supply
Have the On/Off Switch replaced by an authorised
Silverline service centre
Fit new sanding sheet with coarser grit
Fit new sanding sheet with finer grit
Continue sanding
Fit correct sanding sheet
Use less pressure whilst moving the machine
Check connection of the vacuum hose, and ensure dust extraction
system is switched on
Realign sanding sheet; unblock dust extraction holes