Operation - Unold 86430 Instrucciones De Uso

Display:
DE
g Indicator lamp Oscillation
h/m Temperature / Hour display
EN
°C / h
i Indicator lamp Fan operation
FR
j Indicator lamp - low heating capacity
NL k Indicator lamp - high heating capacity
l Indicator lamp Timer
IT
ES
PL

OPERATION

1. Comply with all safety instructions and safety regulations.
2. Ensure that you have selected a safe location.
3. Plug the mains plug of the appliance into an electrical outlet (220–240 V ~
50 Hz).
4. Place the main switch on the rear of the appliance on "I"
5. The appliance is now in standby mode, only the ON/OFF button
active.
6. Press the ON/OFF button. A short signal tone will sound.
7. Caution: The following explanations apply for adjustment on the control
panel itself, and via the remote control unit. The button designation is iden-
tical in each case.
Heating capacity
8. You can select from two heating capacities:
ƒ "Low" level for low capacity
ƒ "High" level for high capacity
9. Note: It takes a few moments until the higher capacity is completely active.
10. Use the
lamp shows the level at which the appliance is operating.
11. The appliance heats until the desired temperature is reached, then the heat-
ing switches off. The appliance will switch on again as soon as the room
temperature drops below the set temperature.
Fan operation
Level "
26 von 76
Copyright UNOLD AG | www.unold.de
button to select the desired capacity. The respective indicator
" for the fan function (cool air)
g
m
l
(approx. 1,000 watt)
(approx. 2,000 watt)
i
h
j
k
is
Stand 24.2.2020