Preparing The Appliance For Operation; Cleaning And Care; Overheating Protection Circuit - Unold 86515 Instrucciones De Uso

preparing THe appLiance For operaTion

1. Ensure that you have selected a safe loca-
tion.
2. Comply with all safety instructions and
safety regulations.
3. Plug the mains plug of the appliance into an
electrical outlet (220-240 V ~ 50 Hz).
4. Select the desired temperature level on the
rotary regulator. To do this, turn the rotary
regulator in the desired direction.
ƒ Low for lower heating temperatures
(1,200 watt),
ƒ High for more heat (2,000 watt)
ƒ Low/Swing for lower heating temperatu-
res (1,200 watt) with oscillating function
(swing function)
ƒ High/Swing for more heat (2,000 watt)
with oscillating function

cLeaning anD care

1. switch off the appliance.
2. unplug the plug from the electrical outlet.
3. allow the appliance to cool completely.
4. Never use any abrasive scouring agents,
steel wool, metal objects, hot
cleaning agents or disinfectants.
5. To clean the filter, open the
filter cover. Remove the filter
and clean it with warm water that
must not be hotter than 30°C.
6. Allow the filter to dry comple-
tely, before you reinsert it. Then
carefully close the filter cover.

oVerHeaTing proTecTion circuiT

1. The appliance is equipped with an overhe-
ating protection circuit that switches the
appliance off when it is heated over 70°C.
2. If the overheating protection circuit has
been tripped, switch the appliance off,
unplug the plug from the electrical outlet
and let the appliance cool for at least 10
minutes.
3. Eliminate the cause of the overheating, (e.g.
excessive dust in the appliance, air outlet
5. The OFF button switches all functions off.
6. As soon as one of the functions is selected,
the indicator light on the lower part of the
appliance shows that the appliance is in
operation.
7. To switch off the functions, turn the rotary
regulator to OFF. The indicator light will go
out.
8. Always switch off the appliance after use
by placing the rotary regulator on OFF, and
unplug the appliance from the electrical
outlet.
Be aware that the appliance can be-
come very hot - fire hazard! Particular-
ly ensure that children are kept away
from the appliance.
7. You can remove dust in the appliance if you
carefully hold a vacuum cleaner against the
air outlet grille or air inlet grille.
8. Store the fan heater in a dry, safe place so
that it is protected from dust, shocks, heat
and moisture.
grille is covered) and start up the appliance
again.
4. If after eliminating the cause, you still can-
not switch the appliance back on, or if the
overheating protection circuit switches on
without an apparent reason, contact our
customer service organisation.
17