Installing Dust Control Bag; Machine Operation - Tennant 2370 Manual De Operador

INSTALLING DUST CONTROL BAG

1. Open the dust bag compartment at rear of
machine by turning the knob counter-clockwise
(Figure 3).
2. Slide the dust control bag collar over the intake
tube as shown. Prior to operating, always check
that an empty dust bag is installed (Figure 3).
FIG. 3

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
NOTE: Make sure the floor is completely dry.
1. Pull and turn the quick-release cord hook upward
and remove the power cord from the machine
(Figure 4).
FIG. 4
Tennant 2370 (11- -06)
Home
2. Plug the power cord into a grounded wall outlet
FOR SAFETY: Do not operate machine unless
cord is properly grounded. Do not operate
machine with damaged cord or plug. Do not
operate machine with the use of an extension
cord.
3. Lower the handle to a desired operating height by
4. To begin burnishing, depress the safety lock
NOTE: As a safety feature, the handle must be
lowered from the upright position in order to activate
the ON/OFF levers.
Find... Go To..
(Figure 5).
Grounded
3 Hole Outlet
Ground Pin
FIG. 5
pulling the handle height adjustment lever.
Release lever to engage handle (Figure 6).
FIG. 6
buttons, located on top of the handle, then pull the
On/Off levers. Release the safety lock buttons
once the machine starts (Figure 7).
FIG. 7
OPERATION
11