Installing Dust Control Bag; Adjusting Control Grip Height; Machine Operation; Pre--Operation Checks - Tennant 2510 Manual De Operador

ATTENTION: Do not operate machine without a
pad and/or centerlock in place.
3. After installing pad, return machine to operating
position.

INSTALLING DUST CONTROL BAG

1. Open the dust control bag compartment at the
front of the machine.
2. Slide the bag over the plastic snout. Close
compartment (Figure 7).
3. Empty or replace the dust bag daily. Do not allow
bag to fill beyond half full.

ADJUSTING CONTROL GRIP HEIGHT

The machine has three control grip height settings.
1. Locate the two spring loaded levers below the
console (Figure 8).
2. Squeeze the levers together and lift or lower
control grips to a comfortable operating height
(Figure 8).
Tennant 2510/2550 (08- -08)
Home
FIG. 7
FIG. 8
Find... Go To..

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
WARNING: Fire Or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine in Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
PRE- -OPERATION CHECKS
1. Sweep floor and remove debris.
2. Check condition of pad.
3. Check battery charge level (For accurate reading
pad must be spinning).
4. Check that the dust control bag is installed.
5. Make sure the floor is completely dry.

BURNISHING WITH 2510 MODEL

1. Turn on key, if equipped, then turn on the main
power switch (Figure 9).
2. Twist control grips forward to lower pad to floor
and to start pad motor (Figure 10).
FIG. 10
OPERATION
FIG. 9
9