Components Layout (B2); Electrical Connections - Aprimatic ZT42 Serie Instrucciones Para La Instalación

R
2.4

COMPONENTS LAYOUT (B2)

A - Aprimatic fl ashing warning/courtesy lamp (to be positioned at a point that is clearly visible from both approaches)
B - Aprimatic safety photocell
C - Manual key-operated control unit (magnetic, digital, keyboard combination lock, mechanical, etc.)
D - Aprimatic microprocessor control unit in watertight container (if possible, to be fitted in a position that is sheltered from
atmospheric agents)
E - Aprimatic remote control radio receiver (can be fi tted inside the fl ashing lamp)
F - Watertight operator electricity supply junction box (recommended) - to be positioned so that the cables are not subject to dangerous
stretching during the movement of the gate leaves
G - Antenna (optional)
H - Aprimatic ZT series operators
I - Electric lock
L - Open position gate stop
M - Closed position gate stop
N - Ground connection for metal framework
Information
Consult the price-list for additional (optional) safety devices.
B2
2.5

ELECTRICAL CONNECTIONS

- When making the electrical connections, carefully follow the instructions for each of the components, referring to the wiring diagram (D1).
- After making the connections, check the thrust force at the end of the gate leaf and set to the correct pressure, following the procedure
described in the next paragraph.
- Before making the pressure settings, open and close the gates electrically a few times to help with the bedding-in, and check that the
motion is uniform throughout the whole movement range.
!
Warning
• The entire circuit must be installed in conformity with the CEI 61-1 and CEI 64-8 regulations.
• Use cable of cross-section 1.5 mm
• If necessary, protect the operator power cable with a sheath; do this before connecting the cable to the junction box.
!
Warning
• Operators come with pickup capacitors.
During installation, connect the capacitor/s to the electrical equipment according to the wiring diagram supplied.
D1
2 for the wiring.
~ 230 V ± 10%
50 Hz
- 17 -
Preliminary operations
1 Radio
2 Flasher unit
3 Receiving photocell
4 Emitting photocell
5 Internal control panel
6 Key control
7 Electrical lock
8 Electronic control unit
9 Junction box