Harbor Breeze 40101 Manual De Instalación página 11

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
7. Insert the downrod (A) into the yoke of the motor
assembly (E), align the holes, and re-install the
downrod clip (DD) and downrod pin (EE). Secure
the motor housing set screws (FF) and slide the
yoke cover (D) down until it rests on top of the motor
assembly (E).
Hardware Used
DD
Downrod Clip
EE Downrod Pin
Motor Housing
FF
Set Screw
8. Carefully lift the downrod (A) onto the mounting
bracket (C). Rotate the downrod (A) until the slot on
the downrod (A) engages the tab on the mounting
bracket (C).
DANGER: Be careful when aligning the tab to
the slot. If not fully engaged, the fan may fall, which
may result in serious injury or death.
9. Connect the green wires from the downrod (A) and
the mounting bracket (C) to the bare/green (ground)
supply wire using a wire connector (BB). Then, wrap
electrical tape around the wire connector (BB) down
to the wire.
Turn the spliced/taped wires upward and gently push
the wires and wire connector (BB) into the outlet box.
Proceed to FINAL INSTALLATION on page 15.
Hardware Used
BB Wire Connector
7
D
DD
x 1
x 1
x 2
8
A
9
x 1
Lowes.com/harborbreeze
11
A
E
EE
FF
C
Tab
Slot
C
A