Flotec FPZT7300 Manual Del Usuario página 5

Operation
1. The shaft seal depends on water for
lubrication. Do not operate the pump unless
it is submerged in water; running it dry may
damage the seal.
2. If the pump overheats, an automatic-reset
thermal protector cuts off the power and stops
the motor before it can be damaged. The
motor will automatically restart when it cools.
If the protector trips repeatedly, unplug the
pump, remove it from the sump, and check
Performance
Model
FPZT7300
5100
FPZT7350
FPZT7450 5460
FPZT7550 5880
Electrical and Switch Specifications
Model Motor HP
FPZT7300
1/2
FPZT7350
FPZT7450 3/4
FPZT7550 1
Figure 7 – LIFT: The vertical distance the pump
actually lifts water. The higher the lift, the lower
the flow.
For parts or assistance, call Flotec Customer Service at 800-365-6832
GPH at total feet of lift
5 ft. 10 ft.
Capacity Gallons/Hour
4140
4500
4980
Motor Full Load
Amps
7.3
7.5
7.9
it for the cause of the difficulty. Low voltage,
long extension cords, clogged impeller, very
low lift, a plugged or frozen discharge pipe,
etc., can all cause cycling and overheating.
3. This pump will not remove all the water in the
sump (see off switch setting, below). If you are
running the pump manually and water stops
coming out of the discharge, the pump has
probably run dry. Shut it off immediately and
check the water level.
15 ft. 20 ft.
2940 1380
3420 2100
4020 2880
Individual Branch
Circuit Req. (Amps)
15
NOTICE The friction caused by water running
through the pipe will also, on longer pipe runs,
reduce the flow. Pipe smaller than the pump
discharge also reduces flow.
25 ft. No flow at
height shown
below
- 23 ft.
420 26 ft.
1500 29 ft.
*Switch Setting in Inches
Water Level For:
On
13-1/2"
7-1/2"
5
Off
4-1/2"
3"