Alcad GRF-200 Manual Del Usuario página 18

Make the electrical connections. Consult wired
diagrams. Check the adjustment. Consult Page
20.
MONITEUR
Connect the monitor connector to the connection
bracket.
Push the monitor downwards (2). While still
pushing (2), apply frontal pressure to the lower
part of the monitor (3) until it is in a position
parallel to the wall. Then move the monitor slightly
upwards to anchor it to the connections support
(4).
D I G I TA L V I D E O D O O R E N T R Y S Y S T E M S
Insert the top two fitting hooks on the bracket into
the guide slots on the back of the monitor housing
(1). To do so, incline the monitor as shown in the
picture below.
Connect the cord between the base of the monitor
and the receiver.