Futurelight 575 SPOT Pro-Head-Spot Manual Del Usuario página 44

- DMX values
Readout DMX values of each channel received by the fixture. Use the [Up] and [Down] keys to select
desired channel and press [Enter] to read its value coming to the fixture or [Mode] to cancel and return to
the menu.
- Display-adjusting
This function allows you to adjust the display settings:
- Display intensity
With this function, you can adjust the display-intensity from 20 % to 100 %. Use the [Up] and
[Down] keys to select the level of the display-intensity and press [Enter] to confirm or [Mode]
to cancel and return to the menu.
- Display-reverse
With this function, you can rotate the display by 180°. Use the [Up] and [Down] keys to select
"normal display" or "display turned by 180°" and press [Enter] to confirm or [Mode] to
cancel and return to the menu.
- Display-On
This function allows you to keep the display on or to turn off automatically 2 minutes after last
pressing any key on the control board. Use the [Up] and [Down] keys to select "On" if you wish
to keep the display on or "Off" if you wish to turn off automatically 2 minutes after last pressing
any key on the Control Board and press [Enter] to confirm or [Mode] to cancel and return to the
menu.
- PAN/TILT-Feedback:
This function allows to return the Mowing Head to the required position after changing the position by
external force (e. g. by stroke). Use the [Up] and [Down] keys to select "On" if you wish to enable this
function or "Off" if you wish not to return the Moving Head to the required position and press [Enter] to
confirm or [Mode] to cancel and return to the menu.
Note: If feedback was switched Off, the PAN/TILT-position is changed by external force and feedbeck is
switched On again, the Moving Head might not to be synchronized with the DMX signal. You have to make a
reset in order to synchronize the Moving Head with the DMX signal.
- Lamp off via DMX
This function allows you to switch off the lamp by DMX. Use the [Up] and [Down] keys to select "On" if you
want to switch off the lamp by DMX or "Off" if you don't want to switch off the lamp by DMX and press
[Enter] to confirm or [Mode] to cancel and return to the menu.
- Temperature
Inside temperature readouts of the fixture in Celsius. Inside temperatures below 80° C are not critical. 80° C
and more lead to the lamp being switched off. Please note that the outside temperature should not exceed
45° C.
- Fan speed operating
By using this function you can choose 5 types of fan speed operating. Browse through this menu by the
pressing [Up] and [Down] keys - the display shows step by step the following messages: "Auto, HIGH, reG,
Lo.HI, Lo.OF". Press [Enter] if you wish to select one of them or [Mode] to cancel and return to the menu.
44/97 51839570_V_1_0.DOC