Futurelight 575 SPOT Pro-Head-Spot Manual Del Usuario página 46

" by which you can adjust the fixture to the required / desired position (0-255) before the function calibration.
Then when the positioning is finished use the last "FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Col1, Col2, PriS,
SGob, rGob, Grot " for very smooth function calibration. Select one of them, press [Enter] and use the [Up]
and [Down] keys in order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Mode]
to cancel and return to the menu. This can be repeated for each calibration parameter if it is required. When
the calibration is finished, it is necessary to use the "ArES" function in order to write the calibration values to
the memory (EEPROM) and to make a reset in order to check the newly adjusted positions of the colour,
gobo and effect wheels. When the reset of the fixture is finished, the display will show the "FCAL" message.
Press [Enter] to repeat the calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Colo, EFEC,
rGob, Grot" - calibration parameters. Select one of them and press [Enter].
Now you can calibrate the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
DMX Calibration protocol:
DMX
1
Channel
COL.1
CALIBRATION
Function
0 - 255
DMX
9
Channel
PRISM
Function
STANDARD
PROTOCOL
After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the
menu without reset by the "ArES" function) and use the "ArES" function in order to write the calibration
values to the memory (EEPROM) and to make a reset in order to check the new adjusted positions of the
colour, effect and rot. gobo wheels and gobo indexing.
2 3
COL.2 SGOB
CALIBRATION CALIBRATION
0 - 255 0 - 255
SMOOTH MICROSTEP MOVEMENT
10 11
STATIC ROTATING
GOBOS GOBOS
STANDARD STANDARD
PROTOCOL PROTOCOL
4 5
RGOB GROT
CALIBRATION CALIBRATION
0 - 255 0 - 255
12 13
GOBO
IRIS
ROTATION
STANDARD STANDARD
PROTOCOL PROTOCOL
46/97
6 7
- COLOURS 1
STANDARD
-
PROTOCOL
14 15
FOCUS STROBE
STANDARD STANDARD
PROTOCOL PROTOCOL
51839570_V_1_0.DOC
8
COLOURS 2
STANDARD
PROTOCOL
16
DIMMER
STANDARD
PROTOCOL