Flex L 7-12 115 Manual De Instrucciones página 12

Instruction manual
3. Using the pin wrench, loosen the clamping
nut on the spindle in a counter-clockwise
direction and remove the clamping nut (2.).
4. Insert the grinding wheel in the correct
position.
5. Screw the clamping nut, with flange
face up, onto the spindle.
6. Press and hold down the spindle lock.
7. Tighten the clamping nut with the pin
wrench.
8. Carry out a test run to check that the
tool is clamped in the center.
Test run
1. Connect the tool to a power source.
2. Switch on the angle grinder with the
switch (without engaging it) and run the
angle grinder for approx. 30 seconds.
Check for imbalances and vibrations.
3. Switch off the angle grinder.
Switching on and off
Brief operation without engaged
switch rocker
1. Push the switch rocker forward and hold
it in position.
2. To switch off the power tool; release
the switch rocker.
12
L 7-12 115 / L 8-11 125 / L 10-11 125 / L 14-11 125 / LE 14-11 125
Continuous operation with engaged
switch rocker
NOTE
Following a power failure, the switched on
power tool does not restart.
1. Push the switch rocker forwards (1.) and
engage by pressing on the front end (2.).
2. To switch off the power tool, release the
switch rocker by pressing the rear end.
Preselecting the speed
(LE 14-11 125)
CAUTION
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continuous operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.