Flex L 7-12 115 Manual De Instrucciones página 13

L 7-12 115 / L 8-11 125 / L 10-11 125 / L 14-11 125 / LE 14-11 125
To set the operating speed, move the dial
to the required value.
Adjusting the guard
CAUTION
Risk of injury! Wear protective gloves.
To adjust the tool to the task at hand, the
guard hood can be adjusted without a tool
among 12 notches on 360°.
1. Disconnect the tool from the power
supply.
2. Turn the guard hood opposite to the
direction-of-rotation arrow on the gear
head to the required position.
Work instructions
NOTE
When the power tool is switched off, the
grinding tool will continue to run briefly.
Rough-grinding
WARNING
Never use cutting-off wheels for rough-
grinding.
Ó Maintain the wheel at an angle between 20°
and 40° for best cutting performance.
Ó Applying moderate pressure, move the
angle grinder backwards and forwards.
This will prevent, the workpiece from
becoming too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue
for the appropriate cutting guard.
Ó Do not press, tilt or oscillate the power tool.
Ó The angle grinder must always be moved
backwards when cutting.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
Ó Adjust the feed to the material which is to
be cut: the harder the material, the slower
the feed.
For further information on the manufac-
turer's products go to www.flex-tools.com.
Instruction manual
13