Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
remaining water can drip out. Leave both
parts to dry. Before reattaching, make sure
that they are completely dry.
B Using the shaver head
attachment
a OptiTrim comb
b Shaver foil
c Trimmer
d Release buttons
e Trim/shave selector
f Cutter block
g Shaver head base
Shaving
•
Put on the shaver head attachment (10) by
clicking it in.
•
Pressing one of the lock keys, turn the
switch clockwise to setting 2.
•
Make sure the trim/shave selector is in the
«shave» position.
•
For best results, always make sure that
both, the shaver foil (b) and the trimmer (c)
are in contact with the skin (A). Keeping
your skin stretched (B), slowly move the
appliance against the direction of hair
growth. The trimmer first raises all long
hairs and cuts them off. Then the flexible
foil follows to smooth away any stubble.
•
When shaving or trimming in sensitive
areas, make sure that you always keep
your skin stretched to avoid injuries.
Contour trimming
For trimming precise line and contours, lock
the long hair trimmer by sliding the trim/
shave selector (e) to the position «trim» (C1).
Pre-cutting hair for epilation
If you choose to pre-cut your hair to the ideal
length for epilation, place the OptiTrim comb
(a) onto the shaver head. Slide the trim/shave
selector to the «trim» position.
Hold the appliance with the OptiTrim comb
lying flat on the skin. Guide it with the comb
tips against the hair growth as shown in
illustration (C2).
N.B. As hair does not always grow in the
same direction, also guide the appliance
slightly diagonally or in different directions in
order to achieve best results.
Cleaning the shaver head
After each use, unplug the appliance.
Brush cleaning
•
Press the release buttons (d) to remove the
shaver head (D1). Tap the bottom of the
shaver head gently on a flat surface (not on
the foil).
•
Brush out the cutter block and the inside
of the shaver head. However, do not clean
the shaver foil with the brush as this may
damage the foil.
Cleaning with water
Press the release buttons (d) to remove the
shaver head. Rinse the shaver head and the
cutter block separately under running water
(D2). Leave the cutter block and the foil frame
to dry separately before reattaching them.
Keeping your shaver head attachment in
top shape
•
The shaving parts need to be lubricated
regularly every 3 months (E). If you clean
the shaver head under running water,
please lubricate it after every cleaning.
•
Apply some light machine oil or vaseline to
the shaver foil and the metal parts of the
long hair trimmer. Then remove the shaver
head and also apply a tiny amount of
vaseline as shown in picture section (E).
•
The shaver foil and the cutter block are
precision parts that wear out with time. To
maintain optimum shaving performance,
replace your foil and cutter block when you
notice a reduced shaving performance.
•
Do not shave with a damaged foil or cord.
11
Publicidad
Tabla de contenido
