Assembly Instructions - Dyna-Glo DGE530SSP Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Assemble the casters, including 2 non-locking
swivel caster (C), 2 locking swivel caster (D),
onto bottom shelf (A) with 4 M6x12 screws (AA),
plain washer (BB) and spring washer (CC) as
shown in below figure.
Hardware Used
AA
M6x12 Screw
Plain
BB
Washer
Spring
CC
Washer
2. Insert 4 M6x12 screws (AA) into holes in bottom
shelf (A), leaving 4-6mm clearance from screw
head to bottom shelf (A). Attached cart left side
panel (H) by placing the panel keyhole over
the screw heads on the left side of
bottom shelf (A), slide the cart left side panel
(H) so that the screw head is over the smaller
part of keyhole. Thread the screws down
snug but do not tighten at this step. Repeat
with cart right side panel (E).
Hardware Used
M6x12 Screw
AA
1
A
x 16
x 16
x 16
2
H
x 4
7
C
AA
D
CC
BB
E
E
A