DeWalt DXCMPA1982054 Manual De Instrucciones página 27

CODE POSSIBLE CAUSE
Low voltage/motor overload
26
Restricted air passages
27
28 Low voltage motor
29 Bad check valve
Seized pump
30
Oil level too high
31
32 Poor ventilation
33 Dirty cooling surfaces
34 Too much back pressure in tank.
Compressor too cold
35
POSSIBLE SOLUTION
Check that power supply is adequate and that compressor is
on a dedicated circuit. If using extension cord, try using without.
If compressor is connected to a circut protected by a fuse, use
dual element time delay fuses (Buss Fusetron type "T" only).
Inspect and replace transfer tubes or check valve, as
required.
Furnish adequate powder.
Replace check valve.
Contact a D WALT factory service center or a D
e
service center.
Reduce to proper level. See Compressor Pump Oil under
Maintenance.
Relocate compressor to an area with cool, dry, well circulated
air, at least 12 in. from nearest wall.
Clean all cooling surfaces thoroughly.
Open drain valve when starting motor.
Move compressor to a warmer location.
27
WALT authorized
e