Connecting Saw To Power Supply; Switching On; Switching Off - Stihl MSE 220 Manual De Instrucciones

Connecting Saw
to Power Supply
The voltage of your power supply and
the voltage specified on the saw must
be the same.
Outdoor operation: Connect the saw
via a ground-fault circuit breaker.
Extension cords must be suitable for
outdoor use.
Mains power outlet: Must be equipped
with a fuse or automatic circuit breaker.
If the fuse or circuit breaker is tripped
when you switch on the saw, use an
extension cord (at least 35 ft /10 m long)
that meets the specifications in the
following table.
Extension cords:
Minimum wire size for extension cords
for 120 Volt appliances:
Cord types SJW-A or SJTW-A
Round jacketed cords.
cord length (ft) 50 100
wire size (AWG) 14 12
Listed by UL, W-A marking on cable
jacket indicates "use outdoors".
Appropriate extension cords are
available in stores spezializing in
electrical equipment.
Cable drum: Always unwind the cord
completely. It should be equipped with
thermal protection.
MSE 220

Switching On

2
: Make sure you have a firm footing.
: Check that bystanders are well clear
of general work area of the saw.
: Hold the saw firmly with both hands.
: Disengage the chain brake by
pulling hand guard back toward the
front handle.
: Check that the chain is not touching
the wood or any other object.
: Press in the trigger switch lockout
button (1) with your thumb.
150
: Squeeze the trigger switch (2) with
10
your index finger.
: Start cutting with the chain running.
1
English / USA

Switching Off

A
: Release the trigger switch so that it
can return to the off position (A). It is
locked in this position by the trigger
switch lockout.
29