Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
Motor Cooling
Cooling air flows to the motor through
the slots in the front handle.
:
Use a dry brush or similar tool to
clean the cooling slots at regular
intervals (see "Maintenance
Chart").
32
Storing the Machine
For periods of about 3 months or longer:
:
Remove and clean the saw chain
and guide bar, spray with corrosion
inhibiting oil.
:
Thoroughly clean the machine,
paying special attenton to the
cooling slots.
:
If you use biological chain and bar
lubricant, e.g. STIHL Bioplus,
completely fill the chain oil tank.
:
Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
Checking and Replacing
the Chain Sprocket
:
Disconnect plug from the power
supply.
:
Remove the chain sprocket cover,
chain and guide bar.
:
Engage the chain brake to lock the
chain sprocket.
Replace the chain sprocket:
a
–
after using two chains or earlier.
–
if the wear marks (a) on the sprocket
are deeper than about 0.02 in
(0.5 mm) since this would reduce
the life of the chain. Check with
reference gauge (Special
Accessory).
It is best to use two chains in
rotation with one sprocket.
Use only original STIHL chain sprockets.
MSE 220
Publicidad
Capítulos
Tabla de contenido
