Mounting The Bar And Chain - Stihl MSE 220 Manual De Instrucciones

English / USA
The chainsaw should also be returned
immediately for maintenance whenever
the brake system cannot be thoroughly
cleaned or there is a change in its
operating characteristics.
Additionally, the daily maintenance
schedule for your chainsaw set forth in
your STIHL Owner's Manual should be
strictly followed.
Store chainsaw in a dry place and away
from children. It should have the
scabbard mounted or be in a carrying
case.
Read all instructions -
save these instructions
24

Mounting the Bar and Chain

You can run chains of different pitches
on this chainsaw – depending on the
chain sprocket (see "Specifications").
The chain pitch must match the guide
bar. The drive link gauge must match the
guide bar groove width.
The pitch is marked in inches on
the sprocket and guide bar (e.g. 3/8
or .325) and the groove width is
additionally marked on the bar in
millimeters (e.g. 1.6)
Do not run non-matching
components together (different
pitches or drive link gauges) since
they will otherwise be damaged
beyond repair within a very short
period of operation.
Do not connect the saw to the power
supply yet.
: Unscrew the nut and remove the
chain sprocket cover.
1
2
: Turn screw (1) counterclockwise
until the tensioning nut (2) butts
against the left end of the housing
slot.
MSE 220